In stock — ships fast

ESP32-S3 4.3" Capacitive Touch Display Board

An ESP32-S3 HMI board with a 4.3-inch 800×480 capacitive IPS touch screen — the bigger canvas for DIY deck and LVGL builds.

Price	A$59.01 A$59.01 · US$38.82 · 38.82 USDC
Payment	AUD card/bank · USDC (Base) · Monero

LAWFUL USE ONLY. A general-purpose touch display development board for your own projects. It is a screen and controller, not a surveillance or interference device.

Compliance: shipped as general-purpose electronics; radio/EMC regulatory status documented per SKU (AU/NZ/US/UK/EU).

About this accessory

When the 2.8-inch CYD feels cramped, this is the step up: an ESP32-S3 driving a 4.3-inch IPS panel at 800×480 with a capacitive touch layer, on a board the CrowPanel/Waveshare HMI class made popular. It runs LVGL, SquareLine Studio exports and Arduino or ESP-IDF builds, and the DIY deck community uses it as the base for larger Bruce and utility frontends. WiFi and BLE are on-module, so the board is a complete touch appliance out of the box — power it over USB-C and you have a touchscreen interface for a home dashboard, a control panel or a portable tool.

Features

ESP32-S3 with 4.3" 800×480 capacitive IPS touch panel
Runs LVGL, SquareLine Studio exports, Arduino/ESP-IDF
WiFi + BLE on the pre-certified module — no extra radio needed
Bigger canvas for DIY deck, Bruce and HMI frontends
USB-C powered; complete touch appliance out of the box

Specs

MCU	ESP32-S3 (WiFi + BLE, pre-certified module)
Display	4.3" IPS, 800×480, capacitive touch
Interfaces	USB-C, GPIO expansion header
Firmware support	Arduino, ESP-IDF, LVGL, SquareLine

In the box

ESP32-S3 4.3" touch display board
USB-C cable

Lawful use. A general-purpose touch display development board for your own projects. It is a screen and controller, not a surveillance or interference device.

In stock — ships fast